Motor and Machine Automation

Motor and Machine Automation

The primary theme of the paper is Motor and Machine Automation in which you are required to emphasize its aspects in detail. The cost of the paper starts from $199 and it has been purchased and rated 4.9 points on the scale of 5 points by the students. To gain deeper insights into the paper and achieve fresh information, kindly contact our support.

Motor and Machine Automation

We have a trim board = 1*4 or 1*6

all boards are white.

we need to design a machine that can do things to the board.

first thing screw some screws. on the door frame, you may have a piece of trim and the door frame about 36" up if you have a door jamb.

we could put brackets on the trim.

the board we got to stack one against another and they`re being shoved into this machine so we need to build a machine over here between the boards to stop and start the board and puts in a bracket. it might have bracket here to screw here screw there. ( same as the figure) between we need a motion control stuff. part of that we going need a coupler nip rollers (coupler, motor,..). will squeezing the board and one of them probably has a motor and one is an ipoare and we`ve got some friction right here so we can drive the boards. then registration sensor, and we need to sensor that can detect the board. then we will have basically a plate we going to amount have two screwdrivers into this plate. we need motion go up and down. and each one has to exist motor, Dc motor ( to perform better torque control in it). ( 1/2 hp brushed motor)

two screws ( 2" and .5") during travel 2.22" and 0.75"

-constant force

- fix time 1.2 to driver screw

- when sensor red should move 36" and stop.

- accy +1.5mm

-cycle time 5 second.

- diameter the roller > 2.5"

- contact whole board.

- pushed with 3lb force from the beginning.

- need to take care of rolling and the tension of rolling.

- length of board 72"-90"

-force 1lb from the middle to the end.

- between the rolling can be bushed, 2 board.

- screw collaboration should be 1.2second to drive screw.

-power supply 110, 230... no limitation.

- the screwdrivers = 20lb.

100% Plagiarism Free & Custom Written, Tailored to your instructions