The selected power and the speed at A and hence th

The selected power and the speed at A and hence the selection of motor, calculation of the belt specifications (belt length, tensions on the tight and slack side). Specifications of the gear box (Speed ratio, power transmitted)

The primary theme of the paper is The selected power and the speed at A and hence the selection of motor, calculation of the belt specifications (belt length, tensions on the tight and slack side). Specifications of the gear box (Speed ratio, power transmitted) in which you are required to emphasize its aspects in detail. The cost of the paper starts from $109 and it has been purchased and rated 4.9 points on the scale of 5 points by the students. To gain deeper insights into the paper and achieve fresh information, kindly contact our support.

Objective:
To experience mechanical engineering design by detail designing the gearbox of a motor-gearbox-belt system whose ‘layout diagram’ is 

given below.
The power P (30KW, 20KW, 10KW,2KW) and ω (1000rpm, 700rpm, 300rpm, 50rpm) are available at A. Select a combination of power 

and angular velocity values to start your design.
(The report has a maximum word limit of 2000 words excluding the contents and the appendix page.)
NB Pro/Engineer users may use Pro/Engineer but no support can be offered to help with difficulties.

Motor
Gear box
Belt drive
A
The contents of the coursework
 The selected power and the speed at A and hence the selection of motor, calculation of the belt specifications (belt length, tensions

 on the tight and slack side). Specifications of the gear box (Speed ratio, power transmitted) (10%)
 Gear tooth calculation using the gear box specification (20%)
 Gear box shaft(s) calculations (30%)
 Engineering drawings of the case which are fully dimensioned in orthographic projection using BS8888 using Inventor. (20%)
 Engineering drawing of the shafts, gears, and other accessories along with an assembly drawing of the gear box which are fully 

dimensioned in orthographic projection using BS8888 using Inventor.. (20%)
The design calculations are on the following topics for guidelines
1. The motor selection to satisfy the power required.
2. the tension in the slack and tight sides of the belt drive
3. the gearbox ratio given rpm at A and motor rotational velocity
4. the ratio of gear trains, worm gear or epicyclic gearboxes
5. the stress in the gear teeth in the gearbox the tolerances on shafts to create a specified fit (*BS4500)
6. stress in the gearbox input and output shafts
7. the outside diameters of gears given the module and number of teeth